ProxmarkPro - Replaying a HID Tag

April 02, 2019

This blog post covers how to replay a tag on the ProxmarkPro. 



What you will need:

Replaying a Tag on hand

1. Depending upon what type of tag you want to replay connect the necessary Antenna. In this example we will be using a HID tag and LF Antenna. 

2. With your LF Antenna connected navigate to the LF Menu, and then HID Menu option.

3. With your HID Tag in field select the Read option. Once the tag is read navigate back to the HID menu.

4. Select Replay from the HID menu options, your tag will now be replaying.

 

5. Place the antenna over your reader. Your tag should now have been read.

Replaying a Tag from Memory

This is very similar to the first example but instead we are going to replay a tag that is saved on the SD Card. 

1. Depending upon what type of tag you want to replay connect the necessary Antenna. In this example we will be using a HID tag and LF Antenna. 

2. With your LF Antenna connected navigate to the Load Tag Menu option. Then select HID and your desired Tag.

3. Once your tag is selected navigate through the HID Menu and select Replay from the menu options.

4. Place the antenna over your reader. Your tag should now have been read.

Note: The range of replay will depend mostly on the reader itself. In our testing we have found replay to work at a maximum range of about 4 cm.  






Also in Blog

ProxmarkPro - General Tag Operations - Getting Started
ProxmarkPro - General Tag Operations - Getting Started

October 15, 2019

This blog post covers operations you can do with tags in Unchained Mode with the ProxmarkPro.

View full article →

ProxmarkPro - Unchained Mode - Getting Started
ProxmarkPro - Unchained Mode - Getting Started

October 15, 2019

Unchained mode is a user friendly on-screen menu to perform various tag operations. This blog post covers the main menus of these operations.

View full article →

ProxmarkPro - Client Setup - Getting Started
ProxmarkPro - Client Setup - Getting Started

October 15, 2019

Follow this guide to learn how to setup the client with the ProxmarkPro. The client is a way to communicate over USB with the ProxmarkPro, you can issue commands and the ProxmarkPro will output the results. The client is accessed through a terminal or command prompt.

View full article →

We use cookies to ensure that we give you the best experience on our website. If you continue we'll assume that you are understand this. Learn more
Accept