Reading Tags with the ChameleonMini Rev.G

January 06, 2017

These step by step instructions cover how to read an HF Tag (13.56 MHz) with the ChameleonMini Rev.G. 

What you will need:

Take a look at the Getting Started Guide if you need help with the setup process.

1. Connect up your ChameleonMini and start the client.

CMini Rev.G Hookup

2. Inside your client enter the following command to configure the ChameleonMini as a reader. 

Config=ISO14443A_READER

Output:

100:OK=ISO14443A_READER

3. Place tag near the ChameleonMini. Run the read command.

GETUID

Outputs:

Mifare Ultalight

101:OK WITH TEXT
041891EA453181

Mifare 1K

101:OK WITH TEXT
5C9F9F0D

Mifare 4K

101:OK WITH TEXT
FE333A53

Mifare Desfire EV1

101:OK WITH TEXT
04113B624D3C80





Also in Blog

ProxmarkPro - General Tag Operations - Getting Started
ProxmarkPro - General Tag Operations - Getting Started

October 15, 2019

This blog post covers operations you can do with tags in Unchained Mode with the ProxmarkPro.

View full article →

ProxmarkPro - Unchained Mode - Getting Started
ProxmarkPro - Unchained Mode - Getting Started

October 15, 2019

Unchained mode is a user friendly on-screen menu to perform various tag operations. This blog post covers the main menus of these operations.

View full article →

ProxmarkPro - Client Setup - Getting Started
ProxmarkPro - Client Setup - Getting Started

October 15, 2019

Follow this guide to learn how to setup the client with the ProxmarkPro. The client is a way to communicate over USB with the ProxmarkPro, you can issue commands and the ProxmarkPro will output the results. The client is accessed through a terminal or command prompt.

View full article →

We use cookies to ensure that we give you the best experience on our website. If you continue we'll assume that you are understand this. Learn more
Accept